Loading ...
Loading ...
Loading ...
FENCE
Figure 24
HOLDDOWN
Figure 25
\
O
C
C
O
The Fence can be moved in and out to accommodate
various size workpbces,
1, To move Fence, bosen Lock Knob (A) See Figure 24,
2, Loosen Fence Lock Handb (C) until the Fence
GUideShaft (B) can slide freeUy,
3, SHde Fence in or out to the desired bcation,
4, Tighten Fence Lock Handb to bck the fence in pUace,
MICRO ADJUST ASSEMBLY
Sometimes it is necessary to move the fence in small
increments, When this is the case, the Micro Adjust
AssemMy shouUd be used,
1, Make sure that the Lock Knob (A) is tightened
down on the Fence GUideShaft (B), See Figure 24,
2, Loosen the Fence Lock Handb (C) so that the
Fence (D) may slide smootHy,
3,
Rotate the Adjustment Knob (E) clockwise to move
the fence in towards the mortiser column, Rotate
counterclockwise to move the fence away from the
mortiser column,
The purpose of the holddown is to prevent the work-
piece from lifting as the chisel is raised up,
1, To adjust, loosen set screw (A), See Figure 25,
2, Position HoUddown (B) until it just touches the top of
the workpbce (C) and allows the workpbce to slide
left or right,
NOTE: The holddown can be turned upside down to
accommodate thicker workpieces,
3, Once Holddown is in position, retighten set screw,
17
Loading ...
Loading ...
Loading ...