Loading ...
Loading ...
Loading ...
MICF{O ADJUST ASSEMBLY F_AISUNG / LOWERING HANDLE
Make sure that the machine is disconnected from the
power source.
Figure 11
Make sure that the machine is disconnected from the
powe r sou rce,
Figure 12
A
C
D c
B
2,
3,
4,
5,
Fit the Micro Adjust Assembly (A) over the Fence
Glide Shaft (B) until the Support Hate (C) is flush
up against the Column (D), See Figure 11,
Align the two hobs in the support plate with the two
hobs in the mortiser column,
Fasten support plate to the column using two M4 x
8mm pan head screws and two M4 fiat washers,
Tighten Lock Knob (E) so that the Micro Adjust
Assembly fits tightly on the Fence Glide Shaft,
Rotate Adjust Knob (F) clockwise to move the
Fence Assembly towards the Mortiser column,
Turn counter clockwise to move the fence away
from the Mortiser,
1, Line up the notches in the hub of the handle (A)
with the slots in the gear shaft (B), See Figure 12,
NOTE: The handle may be attached to either the left
side or right side, depending on your preference,
2, Place spring (C) over the shoulder bolt (D) and
insert through the hub of the handle, Tighten using
supplied L =Handle 8mm allen wrench,
NOTE: The handle is spring loaded, You can reposition
it by pulling it out and repositioning it on the gear shaft,
12
Loading ...
Loading ...
Loading ...