CM61082-S User Manual

Loading ...

17 - ENG

WARNING: To reduce the possibility of contamination always protect

against backflow when connected to a potable watersystem.

7. Choose the correct nozzle for the job to be performed. See How To Use spray

Wand instructions in this section. NOTE: If applying a chemical or cleaning

solution, see How To Apply Chemicals/Cleaning Solvents instructions in

thissection.

8. Turn water source on.

NOTICE: Risk of property damage. Failure to do so could cause damage to

thepump.

9. Remove all air from the pump and high pressure hose by depressing trigger

until a steady stream of water is present.

10. Start engine. See Engine Owner’s Manual for correct procedure.

WARNING: Risk of unsafe operation. If engine does not start after two

pulls, squeeze trigger of gun to relieve pump pressure. Pull starter cord slowly

until resistance is felt. Then pull cord rapidly to avoid kickback and prevent

hand or arminjury.

11. Depress trigger on gun to start water flow.

WARNING: Risk of unsafe operation. Stand on a stable surface and

grip gun/spray wand firmly with both hands. Expect the gun to kick

whentriggered.

12. Release trigger to stop waterflow.

WARNING: Do not allow the unit to run for more than two minutes without

the gun trigger being pulled. This could cause overheating and damage to

the pump. When the temperature inside the pump rises too high, the thermal

relief valve will open and release a spray of water from the pump to lower the

internal temperature. The valve will thenclose.

WARNING: Risk of injury from spray. Always engage the

trigger lock (O) when gun is not in use. Failure to do so

could cause accidentalspraying.

SHUTTING DOWN

1. After each use, if you have applied chemicals, place

detergent siphon hose into container of clean water

and draw clean water through chemical injection system to rinse system

thoroughly.

NOTICE: Risk of property damage. Failure to do so could cause damage to

thepump.

2. Turn engine off. See Engine Owner’s Manual.

NOTICE: Risk of property damage. NEVER turn the water off with the enginerunning.

3. Turn water sourceoff.

4. Pull trigger on spray gun to relieve any water pressure in hose or spraygun.

NOTE: Failure to release system pressure will prevent removal of high pressure

hose from spray gun or pumpconnection.

5. See Storage section in this manual for proper storageprocedures.

Loading ...

User Manual - Page 17