Loading ...
Loading ...
Loading ...
15 - ENG
3. Install the black low pressure nozzle into the quick connect fitting of the spray
wand. (if equipped) Rotate the Dial-N-Wash (L) to the MAX pressure setting as
shown in Figure 6. See How To Use Spray Wand paragraph in thissection.
NOTE: To apply chemicals the black low pressure nozzle must be installed and
the Dial-N-Wash must be in the MAX pressure setting as shown in Figure 6.
4. After use of chemicals, place detergent siphon hose into container of clean
water and draw clean water through chemical injection system to rinse sys-
tem thoroughly. If chemicals remain in the pump it could be damaged. Pumps
damaged due to chemical residue will not be covered underwarranty.
NOTE: Chemicals and soaps will not siphon if the black soap nozzle is not installed
on the spraywand.
To Apply Chemicals (Detergent Tank, if equipped):
1. Remove the cap from the detergent tank (F, Figure 9) and fill the detergent
tank with cleaning solvent. Replace cap on deteregent tank. NOTE: For every
7 gallons of water pumped 1 gallon of chemical/cleaning solution will beused.
2. Install the black low pressure nozzle into the quick connect fitting of the spray
wand and rotate the adjustable pressure regulator (F) to the MAX pressure
setting as shown in Figure 6. See How To Use Spray Wand paragraph in
thissection.
NOTE: To apply chemicals the black low pressure nozzle must be installed
and the adjustable pressure regulator must be in the MAX pressure setting as
shown in Figure 6.
NOTE: After squeezing the trigger it will take approximately 5 seconds for the
detergent toappear.
3. After use of chemicals, fill the detergent tank with clean water and draw
clean water through chemical injection system to rinse system thoroughly. If
chemicals remain in the pump it could be damaged. Pumps damaged due to
chemical residue will not be covered underwarranty.
NOTE: Chemicals and soaps will not siphon if the black soap nozzle is not installed
on the spraywand.
STARTING (FIG. 10–13)
WARNING: To reduce the risk of injury, read the pressure washer instruction
manual and the engine instruction manual before starting pressurewasher.
DANGER: Risk of fluid injection and laceration. When using the high
pressure setting, DO NOT allow the high pressure spray to come in contact
with unprotected skin, eyes, or with any pets or animals. Serious injury
willoccur.
• Your washer operates at fluid pressures and velocities high enough to penetrate
human and animal flesh, which could result in amputation or other serious injury.
Leaks caused by loose fittings or worn or damaged hoses can result in injection
injuries. DO NOT TREAT FLUID INJECTION AS A SIMPLE CUT! See a physician
immediately!
DANGER: Carbon Monoxide. Using an engine indoors can kill you in
minutes. Engine exhaust contains high levels of carbon monoxide (CO), a
poisonous gas you cannot see or smell. You may be breathing CO even if you
do not smell engine exhaust.
• Breathing ex haust fumes will cause se ri ous injury or death! En gine exhaust
contains carbon mon ox ide, an odorless and deadlygas.
Loading ...
Loading ...
Loading ...