Loading ...
Loading ...
Loading ...
PRODUCT
OPERATION
The importance of the installation
ofyour Sub-Zero cannot be over-
emphasized. The proper in-
stallation of your unit is the
responsibility of the selling dealer
or installer. Any questions or
problems pertaining to the installation
should be directed to the selling
dealer.
TEM; ERATURE
CONTROLS
Your new refrigerator/freezer was
thoroughly inspected and tested
before itwas shipped from the
Sub-Zero factory. During these
procedures, the temperatures
were preset to maintain approxi-
mately 38 degrees in the refrigera-
tor section and approximately 0
degrees in the freezer section. If
you wish to adjust the temperature,
simply turn the control dial. The
illuminated dial indicates the
control setting, #1 warmest to #10
coldest. See Figures 1,2, and 3.
You should be aware it is normal
for temperatures to fluctuate
slightly depending on external
influences, such as: an open door
for extended periods, the degree
of humidity present and room
temperature.
Figure 1
NOTE: Always allow 24 hours
for the refrigerator to reach the
temperature you set.
MODELS 532, 542 AND 561
The refrigerator control islocated
on the back wall of the refrigerator
near the top right. See Figure 1.
The freezer control is located on
the freezer panel just above the ice
drawer. Toadjust, pull the drawer
out, on the left side of the panel
turn the control dial until the
desired setting appears on the
panel. See Figure 2.
Figure 2
•MODELS 511 AND 550
The refrigerator and freezer
controls are both located on the
back wall of the refrigerator near
the top. The refrigerator control is
on the right and the freezer
control is on the left. See Figure 1.
MODELS 501F AND 501R
The temperature control for each
model is located on the back wall
of the unit near the top right. See
Figure 1.
MODEL 590
The refrigerator and freezer con-
trols are both located inside the
refrigerator section on the left hand
side at a convenient level. See
Figure 3.
Figure 3
CRISPER DRAWERS
To remove your crisper drawer,
pull open until drawer stops. Raise
front of crisper and pull out as
shown in Figure 4. To reinstall:
With the front of the crisper raised,
insert crisper into the tracks. See
Figure 4.
Figure 4
Loading ...
Loading ...
Loading ...