Loading ...
Loading ...
Loading ...
Brush
Support
Base
4. Carefully
insert and lift
screwdriver at
each brush
support tofree
brush from
base.
5,Remove belt
from motor
shaft,
6, Remove
worn belt.
!
• CAUTION .......
When you remove the brush
supports, a small metal washer on
each end may come off. DO NOT
lose these two metal washers,
, ,i i i
7. Slide brush "/" " >-_r'-F
supports off to check
and clean brush
support areas. See
BRUSH ASSEMBLY
for picture of cornptete
brush assembly.
TO REPLACE BELT
1. Slide washers
and brush supports
onto brush assem-
bly,
2. Install new
belt in belt
grooveon
the brush
assembly,
thenover the
motor shaft.
Be sure belt
is under the
belt guard.
NOTE: See PARTS AND FEATURES for
Belt number.
3. Insert both
support tabs
intothe base
slots. Then
snap brush
supports into
place.
4, Line up
tabs on front
of base with
slots inside
the front
cover.
Cover
Slot Front
Base Tab
5. Tiitcoverto
back. Press
coverfirmly
untitreartabs
snapinto
place.
Rear Base Tab
TurnPower-Mate_over. Replace the cover
screws and lower the pile heightadjustment
rollers intoplace. Replace light bulb and
cover, if on your model,
18
Loading ...
Loading ...
Loading ...