Loading ...
Loading ...
Loading ...
TO CLEAN AGITATOR:
1. Remove
lightcoverby
pressing in
and lifting both
sides as
shown.
NOTE: Inorderto keep cleaning efficiency
high and to preventdamageto your vacu-
um, the agitator must be cleaned every_time
the belt is changed.
The agitator must also be cleaned accord-
ing to thefol]owingschedule:
Vacuum Use Clean Agitator
HEAVY - everyweek
(used daily)
MODERATE -
(used 2-3 timeslweek)
LIGHT -
(used 1 time!week)
every month
every 2 months
Remove any dirt or debris in the belt path
area or in the brush roller area.
Carefully remove any string or debris
located on the agitator, end caps, wash-
ers or agitator shaft.
IMPORTANT
Replace the
washers and
the end caps.
See the
exploded view
for correct
assembly.
2. Push inand turn
bulb counterclockwise
to remove.
3. Replace the bulb.
Bulb must not be high-
er than 15Watts (130
volts). Close light cover
until it snaps in place.
NOTE: See PARTSAND FEATURESfor
Bulb Number,
Disconnect cleaner from electrical out-
let. Checkand remove hair,string and lint
build-up frequently inthe PowePMate®
brush andbrush support areas, if build-up
becomes excessive, disconnect Power-
Mate®from wand and follow the steps
below. Instructions can also be found under
the light cover.
TO REMOVE BELT
_m
1. Remove light
coverand light bulb,
ifonyour model.
Turn Power-Mate®
over, raise pile
heightadjuster
rollersand remove
the two screwsfrom
the base.
2. Insert andtwist
fiat screwdriver
underbothback
covertabs.
3. TurnPower-
Mate®rightside
up. Tilt cover
forward from
back untilfront
snapsfree.
17
Loading ...
Loading ...
Loading ...