Loading ...
Loading ...
Loading ...
EDGE CLEANER
1_ ctive brush edge
cleaners are onboth
sides ofthe Power-
Mate®.Guide either
side ofthe Power-
Mate®along base-
boardsor next to
furniture to help
remove dirt trappedat
carpet edges.
OVERLOAD PROTECTOR
The Power-Mate®has
built-in protection against
motor and belt damage
Shouldthe brushjam. If
the brush slowsdown or
stops, the overload
protector button pops up
and shuts off the Power-
Mate®.The canister motor
will continue to run.
To correct problem: See
TROUBLESHOOTING.
To reset: Push in the overload protector
button.
SUCTION CONTROL
The suction
control allows
you tochange
the vacuum
Suction Suction suctionfor
differentfabric
and carpetweights.Openingthe control
decreases suction for draperiesand
lightweightrugs,while closingthecontrol
increasessuction forupholsteriesand
carpets.
WARNING
Personal injury Hazard
Always unplug the vacuum cleaner
before cleaning the brush area as
brush may suddenly restart. Failure
to do so can result in personal
injury.
i Hjlll ii i lllllllll
1t
AUTO-CLEANING SYSTEM
This vacuumisequippedwith a auto-cleaning
system. Eachtimethepowercordisextended
a cleaningcam locatedinsidethe dustbin
rotatesand cleansthefilter.
POWER-MATE ®STORAGE
SOME MODELS
The lowerwand has
a"U" shapedflange
in the area where
the power cord
attaches.The canis-
ter hasa "U"
shaped slot near the
rear ofthe canister,
The slot allowsthe wandsandPower-Mate®
to be stored with the canister to conserve
storage space.
The wand will slip out of the slot as itis lift-
ed up for use and will slide into the slot asit
is lowered forstorage.
THERMAL PROTECTOR
This vacuumhas a thermalprotector which
automatically tripstoprotectthe vacuum
from overheating. The thermal protector
turns the motor off automatically to allow the
motor to cool in orderto preventpossible
damage to the vacuum.
To reset: Turn off and unplug the vacuum
from the outlet to allow the vacuum to coo[.
Check for and remove any clogs. Also
check and replace any clogged filters.
Wait approximately 30 minutes and plug
the vacuum in and turn back on to see if
the thermal protector has reset. In some
cases, the unit may suddenly restart. DO
NOT leave unattended while plugged in.
Loading ...
Loading ...
Loading ...