Loading ...
Before beginning assembly, installation or operation of product, make sure all parts are present. Compare parts with
package contents list and diagram on previous page. If any part is missing or damaged, do not attempt to assemble,
install or operate the product. Contact customer service for replacement parts.
Tools Required for Assembly (not included): Slotted Screwdriver, Phillips Screwdriver, Pliers, Electrical Tape, Wire
Cutters, Safety Glasses, Ladder, Wire Stripper, Power Drill.
Page 2 of 4
SAFETY INFORMATION
PREPARATION
211019
ASSEMBLY INSTRUCTIONS
Turn off the power at fuse or circuit box.
1. Loosen the 2 mounting base screws
using a philips screwdriver.
Take apart the lamp shade from
base.
3. Remove the protective paper from
the adhesive gasket (AA), and
thread the fixture wires through
gasket (AA) to align the hole of
gasket (AA) and the installation
hole at the back of light, then adhere
the gasket (AA) to the back of light.
2. Drill installation holes at the back
of the light. Measure the size of
your outlet box to match the fixed
screw hole and mark the hole
position to drill out by power drill.
1
Screw
2
Outlet Box
4. Make wire connections using
attached three wire connector (CC)
as follows:
Black to Black
White to White
Green Ground to house Ground
Please read and understand this entire manual before attempting to assemble, operate or install the product.
WARNING
● Turn off electricity at main fuse box (or circuit breaker box) before beginning installation by removing fuse (or
switching off circuit breaker).
● Be careful not to damage or cut the wire insulation (covering) during fixture installation. Do not permit wires to contact
any surface having a sharp edge. To do so may damage or cut the wire insulation, which could cause serious injury
or death from electric shock.
CAUTION
● All electrical connections must be in agreement with local codes, ordinances or the national electric code (NEC).
Contact your municipal building department to learn about your local codes, permits and/or inspections.
● Risk of fire – most dwellings built before 1985 have supply wire rated for 140°F/60ºC. Consult a qualified electrician
before installation.
● Do not connect this fixture to an electrical system that does not provide a means for equipment grounding. Never use
a fixture in a two-wire system that is not grounded. If you are not sure your lighting system has a grounding means,
do not attempt to install this fixture. Contact a qualified, licensed electrician for information with regards to proper
grounding methods as required by the local electrical code in your area.
● Only general ON/OFF wall switch applies for this fixture, the dimmable wall switch shouldn't be required.
Rated Wattage: 120W
Work Temperature: -13°F~113°F
4
Outlet Box
CC
Photocell
3
AA
Loading ...
Loading ...