Loading ...
Loading ...
Loading ...
Care and Cleaning
Burn Hazard
Allow heating element to cool
before cleaning the interior.
Failure to do so can result in
burns.
Outside--Occasionally wash with a mild
nonabrasive detergent and water. Rinse and dry.
Inside--The inside of the dishwasher is self-
cleaning with normal use.
If hard water causes lime deposit buildup, clean
using the following instructions:
1. After dishwasher begins to fill, open door and
pour 2 cups of white vinegar into dishwasher.
Do not add dishes or detergent.
2. Run through any full wash cycle.
If it is felt that further interior cleaning is needed,
general household spray cleansers are
recommended. Follow manufacturer's directions.
Important: The dishwasher motor is
permanently lubricated at the factory and does
not need to be oiled.
Float--is used to measure water level in
dishwasher. See page 4 for location.
Clean float with
household
cleanser
containing
vinegar or bleach
to dissolve any
buildup. Cleaning
will prevent float
from sticking and
stopping a water
fill or allowing
dishwasher to
overflow.
Clean and
remove
particles
collected here
Float
Float Guide
Pull up firmly to lift float out. Clean around
areas shown in illustration.
To replace float, push down until float locks into
place.
Float should move up and down freely about
one inch when replaced on tube.
Cleaning the Pump and Spray
Arm
Your dishwasher will flush away all normal food
soils. However, objects (bones, fruit pits, etc.) may
collect in openings and should be removed
periodically to avoid clogging drain system.
Tow Arm
Heatinc_ Element
(caution)
ump Opening
1. Remove tower base by turning counterclock-
wise.
2. Remove Iocknut and spray arm.
3. Clean out spray arm holes.
4. Clean in and around pump openings.
5. Replace spray arm and securely tighten
Iocknut. Spray arm should rotate freely.
6. Replace tower base.
Care of Drain Air Gap
If a drain air gap was installed for your built-in
dishwasher, check to make sure it is clean so the
dishwasher will drain properly. Drain air gaps are
usually mounted on countertop and can be
inspected by removing the cover. A drain air gap
is not part of your dishwasher and is not covered
by this warranty.
10
Loading ...
Loading ...
Loading ...