Loading ...
Loading ...
Loading ...
4
Installation continued
* All dimensions shown above are in mm
TO INSTALL
To install the rangehood you will need to drill four 6mm holes into the base of the cabinet to correspond with the
existing holes in the rangehood as shown in the drawing above.
To allow the ducting vent and power cord to fit into the cabinet, you will need to cut a 280mm x 200mm hole into
the base of the cabinet as shown in the diagram above.
PLEASE NOTE: Using the incorrect screws for the installed mounting method as per these instructions may
cause damage to the product. This damage may lead to failure of the anchor points and this would not be
covered by the warranty.
Operating instructions
Light
The light can be operated independently from the fan and is controlled in accordance with the graphics printed on
the control panel.
Automatic function will turn the fan and lights on when the slide out is pulled out.
Fan
The fan can be run at different speeds depending on the cooking requirements and is controlled in accordance
with the graphics printed on the control panel.
6mm
holes
6mm
holes
Cabinet
Loading ...
Loading ...
Loading ...