Loading ...
Loading ...
Loading ...
WARNING:
IF YOU DO NOT FOLLOW THESE INSTRUCTIONS
A FIRE OR EXPLOSION MAY RESULT CAUSING
PERSONAL INJURY OR LOSS OF LIFE.
SEE INSTALLATION INSTRUCTIONS.
A. THIS FIREPLACE IS EQUIPPED WITH AN IGNITION DEVICE WHICH
AUTOMATICALLY LIGHTS THE PILOT. DO NOT TRY TO LIGHT BY HAND.
B. BEFORE OPERATING SMELL ALL AROUND THE FIREPLACE AREA FOR GAS
AND NEXT TO THE FLOOR BECAUSE SOME GAS IS HEAVIER THAN AIR AND
WILL SETTLE ON THE FLOOR.
WHAT TO DO IF YOU SMELL GAS:
TURN OFF ALL GAS TO THE FIREPLACE.
23(1:,1'2:6
'212T TRY TO LIGHT ANY APPLIANCE.
'212T TOUCH ANY ELECTRIC SWITCH; DO NOT USE ANY PHONE IN YOUR
BUILDING.
,00(',ATELY CALL YOUR GAS SUPPLIER FROM A NEIGHBOUR’S PHONE.
FOLLOW THE GAS SUPPLIER’S INSTRUCTIONS.
,) YOU CANNOT REACH YOUR GAS SUPPLIER, CALL THE FIRE DEPARTMENT.
C. DO NOT TRY TO REPAIR ANY PART OF THIS ASSEMBLY. CALL A QUALIFIED
SERVICE TECHNICIAN. FORCE OR ATTEMPTED REPAIR MAY RESULT IN A FIRE
OR EXPLOSION.
D. DO NOT USE THIS FIREPLACE IF ANY PART HAS BEEN UNDER WATER.
IMMEDIATELY CALL A QUALIFIED SERVICE TECHNICIAN TO INSPECT THE
FIREPLACE AND REPLACE ANY PART OF THE CONTROL SYSTEM AND ANY GAS
CONTROL WHICH HAS BEEN UNDER WATER.
TO TURN OFF GAS
2. TURN MANUAL SHUTOFF VALVE CLOCKWISE TO OFF. DO NOT
FORCE.
1. STOP! READ ALL INFORMATION OF OPERATING AND LIGHTING
INSTRUCTIONS BEFORE PROCEEDING.
2. THIS FIREPLACE IS EQUIPPED WITH AN IGNITION DEVICE WHICH
AUTOMATICALLY LIGHTS THE PILOT. DO NOT TRY TO LIGHT THE PILOT BY
HAND.
3. TURN MANUAL SHUTOFF VALVE CLOCKWISE
TO OFF.
4. WAIT FIVE (5) MINUTES TO CLEAR OUT ANY GAS. IF YOU
SMELL GAS INCLUDING NEAR THE FLOOR, STOP! FOLLOW
“B” OF THE OPERATING INSTRUCTIONS. IF YOU DON’T
SMELL GAS GO TO THE NEXT STEP.
5. TURN MANUAL SHUTOFF VALVE COUNTER-CLOCKWISE
TO ON.
6. TURN ON MAIN BURNER.
IF THE APPLIANCE WILL NOT OPERATE, FOLLOW THE INSTRUCTIONS “TO
TURN OFF GAS” AND CALL YOUR SERVICE TECHNICIAN OR GAS SUPPLIER.
OPERATING INSTRUCTIONS
W385-1902_B
FOR YOUR SAFETY READ BEFORE OPERATING
LIGHTING INSTRUCTIONS
EXACTLY,
PROPERTY DAMAGE,
A. Locate the pilot adjustment knob on
the bottom right of appliance.
B. Push and turn the knob counter
clockwise to the “PILOT ON” position
and hold for a few seconds to ignite
the pilot.
C. Once the pilot is lit, slightly push the
knob and turn counter clockwise to
light the main burner.
D. To adjust the fl ame height, push the
knob and turn to desired height.
NOTE: When fi rst lighting the pilot, push the
knob and hold for 30 seconds to purge the
gas line. WARNING: Do not hold for more
than a minute.
W415-1158 / B / 01.09.17
17
EN
6.0 OPERATION
When lit for the fi rst time, the appliance will emit a slight odour for a few hours. This is a normal temporary
condition caused by the “burn-in” of internal paints and lubricants used in the manufacturing process and
will not occur again. Simply open a window to suffi ciently ventilate the room. After extended periods of non-
operation such as following a vacation or a warm weather season, the appliance may emit a slight odour for
a few hours. This is caused by dust particles in the heat exchanger burning off. Open a window to suffi ciently
ventilate the room.
6.1 LIGHTING AND OPERATING INSTRUCTIONS
Loading ...
Loading ...
Loading ...