Loading ...
Loading ...
Loading ...
SOFIWARESETT1NCS
HelpfulHints • The installer automatically updates your SYSTEM.INI Windows@
file by adding DEVICE=bi-di.386 under the [386Enh] section. If any
bidirectional parallel communications device driver has previously
been installed, it will be deactivated by this new driver. If you want
to use the driver that was previously installed, you should first
install this driver, then reinstall your previous driver. However,
reinstalling the previous driver will make the MFC driver inactive.
• The installer makes the installed printer driver the Windows@
default.
* The installer automatically sets the printer port to the parallel
interface, LPT1.
• During this installation, changes have been made to the
SYSTEM,INI file. It is necessary to restart Windows@ so that the
changes become effective and the installed bidirectional parallel
communications device driver can take effect.
2) FOR DOS USERS (Only for MFC 6550MC/7550MC)
How to Use the MFC with Your DOS Application Software
Before working with your application software that runs on DOS or Windows MS-
DOS Prompt, check that the machine's name (MFC) appears in the printer selection
of your application software. If the MFC is not listed, you must install the printer
driver that corresponds to HP LaserJet liP's emulations.
The following table shows combinations ofprinter drivers and emulation mode. To get
the most out of this machine, you should install an lip printer driver in your
application software.
Printer driver supported in Emulation mode to be selected with
your application software the remote printer console program
lIP LaserJet IIP TM HP LaserJet IIP emulation mode
HP LaserJet II TM Auto emulation selection
HelpfulHints • The best or recommended printer driver is indicated in bold.
• Be sure to choose the proper printer driver in your application
software.
• Be sure the printing resolution is set to 309 dpi in your DOS
application software.
" '" " '"' I"5
3-
Loading ...
Loading ...
Loading ...