Loading ...
Loading ...
Loading ...
13
OPERATING YOUR APPLIANCE
Control Panel
The appliance should be placed where the ambient temperature is between 41 and 90°F (5 to 32°C). If
the ambient temperature is above or below this range, the performance of the unit may be affected. For
example, placing your unit in extremely cold or hot conditions may cause interior temperature to fluctuate.
1. Up ︿: Used to raise (warm) the set temperature by 1°C or 1°F.
2. Temperature Display: The display normally indicates the current operational temperature; when
blinking it shows the set temperature.
3. C/F: Shows temperature scale of current display, C (Celsius) or F (Fahrenheit).
4. Down ﹀: Used to lower (cool) the set temperature by 1°C or 1°F.
5. SET temperature: Press this button, then ︿ or ﹀ to set temperature.
6. °C/°F Selector: Changes display temperature from Celsius to Fahrenheit, and vice versa.
7. Power Button: Turns the appliance ON or OFF.
Setting the Temperature Control
1. Connect the power cord to a properly grounded outlet.
2. Set the desired cooling temperature by pressing the SET button first, then the corresponding
button ﹀ or ︿. Each depression of the buttons will raise or lower the temperature setting by 1
degree. The temperature selected will flash in the LED display for approximately 5 seconds, then
revert back to display the temperature of the interior cabinet.
NOTES:
• The temperature setting can be adjusted from 1°C to 8°C（from 34°F to 46°F).
• To view the “set” temperature anytime, press ﹀ or ︿ once. The “set” temperature will flash in the
LED display for 5 seconds.
• This unit has the option of displaying temperatures in either Celsius or Fahrenheit. To change the
setting, press the °C/°F button.
• The temperature inside the cabinet may vary slightly depending on whether stored items are located
in the upper or lower section.
• In the event of a power interruption, the appliance will save the “set” temperature data. When power
is turned on again, the previous “set” temperature will be in effect.
Loading ...
Loading ...
Loading ...