Loading ...
Loading ...
Loading ...
• Insert the short end of the 1/8" hex key wrench (packed
with the Door Handle Installation Instructions) into the
bottom hinge pin until it is fully engaged in the
alignment screw.
To raise the door, turn the hex key to the right.
To lower the door, turn the hex key to the left.
• Continue to turn the alignment screw until the doors are
aligned.
6. Make sure the refrigerator is steady. If the refrigerator
seems unsteady or rolls forward when a door or drawer is
pulled open, adjust the brake feet.
To Steady the Refrigerator..
• Open the freezer drawer. Using a 1/4" hex driver, turn
both brake feet clockwise the same amount until the
brake feet are snug against the floor. Check again. If not
satisfied, continue to adjust the brake feet by half turns
of the screw until the refrigerator does not roll forward
when the drawer is opened.
NOTE. Having someone push against the top of the
refrigerator takes some weight off the brake feet. This
makes it easier to turn the screws.
7. Replace the base grille by aligning the ends of the grille with
the leveling assemblies on each side and snapping the grille
into place.
FILTERS AND ACCESSORIES
Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction
may be used on disinfected waters that may contain
filterable cysts.
Install the Water Filter
.
2.
Locate the accessory packet in the refrigerator and remove
the water filter.
Take the water filter out of its packaging and remove the
cover from the O-rings. Be sure the O-rings are still in place
after the cover is removed.
3. The water filter compartment is located in the right-hand
side of the refrigerator ceiling. Push up on the compartment
door to release the catch, then lower the door.
4.
.
6°
7.
Align the arrow on the water filter label with the cutout
notch in the filter housing and insert the filter into the
housing.
Turn the filter clockwise 90 degrees (1/4turn), until it locks
into the housing.
NOTE: If the filter is not correctly locked into the housing,
the water dispenser will not operate. Water will not flow
from the dispenser.
While the compartment door is still open, lift the filter up
into the compartment. Then, close the filter compartment
door completely.
Flush the water system. See "Flushing the Water Filter" in the
"Water and Ice Dispensers" section.
IMPORTANT: If you do not flush the water system, you may
experience dripping and/or decreased flow from the water
dispenser.
A. O-ring cover
B. O-rings
16
Loading ...
Loading ...
Loading ...