Loading ...
Loading ...
Questions, problems, missing parts?
Before returning to your retailer, call our customer service at 855-232-6423
Monday – Friday 8:00 a.m. – 8:00 p.m. (EST)
BATTERY REPLACEMENT
FREQUENTLY ASKED QUESTIONS
OPERATIONAL INSTRUCTIONS
Please slide the OFF-ON switch to "ON" position and linked your lights (if needed) before install your lights as above.
While slide the OFF-ON switch to "ON" position the light will turn on and enter a "warm-up" period for about 15 seconds, the light illuminates
automatically at dusk using an energy saving mode of low brightness.
When motion is detected at night, the light illuminates at full brightness for approximately 20 seconds.
Fully charged use for this light is approximately 36 minutes calculated using 20 seconds per cycle.
The light will not turn on at daytime.
Q: Where should the solar panel be mounted?
A: Mount your solar panel in a position that will enable the most amount of light to be absorbed. In the Northern Hemisphere this is usually south
facing.
Q: Does the solar panel require direct sun to charge?
A: The solar panel can charge the internal battery in direct and indirect light. For best results, try to keep your solar panel’s sun exposure.
Q: Will decorative or street lights have an effect on the motion sensor's ability to operate?
A: Yes, the sensor of the solar wall light is light-sensitive. For nighttime usage, ensure no other light affects the motion sensor.
Q: What type of battery does my solar wall light require to operate?
A: Your solar wall light requires the use of 1 pc of 3.7V 18650 1,800 mAh Lithium ion rechargeable battery (18650 3.7V 2,000mAh Lithium ion
rechargeable battery can works in this unit too).
When replacing the batteries, be sure to:
• Use same specification rechargeable battery (1 pc 18650 3.7V 1,800mAh Lithium ion rechargeable battery,
18650 3.7V 2,000mAh Lithium ion rechargeable battery can works in this unit too).
• Observe the correct polarity (+ and -) when installing the replacement battery.
• IMPORTANT: Dispose of the Lithium ion battery in accordance with local,
state and federal regulations.
Battery is located in the battery housing behind the light fixture.
Slide the OFF-ON switch to OFF position on the light prior to opening the battery housing.
Remove the screws to reveal the battery.
When replacing the battery, observe the correct polarity and match the battery specification with the battery you have removed.
Use rechargeable battery only.
The first time use after new battery change. Slide the OFF-ON switch to ON position the light will turn on and enter a "warm-up"
period for about 15 seconds.
Recommended installation height: 4.5 ~ 8 feet above the ground.
At such a height, The fixture will provide a detection distance of up to 26 feet (Max) at ambient temperature of 77 degrees Fahrenheit.
The sensor will be more sensitive to motion across than motion towards it directly.
ONE-YEAR LIMITED WARRANTY:
If, during normal use, this PATRIOT LIGHTING
®
lighting fixture breaks or fails
due to a defect in material and workmanship within one (1) year from the date of original purchase,simply bring this
lighting fixture with the original sales receipt back to your nearest MENARDS
®
retail store. At its discretion, PATRIOT
LIGHTING
®
agrees to have the product or any defective part(s) repaired or replaced with the same or similar PATRIOT
LIGHTING
®
product or part free of charge, within the stated warranty period, when returmed by the original purchaser
with original sales receipt. This warranty; (1) excludes expendable parts including but not limited to light bulbs and
batteries; (2) does not cover damage that has resulted from abuse or misuse; and (3) does not cover any losses,
labor, injuries to persons/property or costs. This warranty does give you specific legal rights and you may have other
rights, which vary from state to state.
3
Loading ...