Loading ...
Loading ...
Loading ...
# Section Heading
Zip Domestic Chill Tap - Installation & Operating Instructions - 87403 - June 2007 Page 5 of 8
Take care, when bending rigid plastic tubing, to prevent it from kinking or
crushing around a bend. As it is plastic tubing containing water under mains
pressure, be careful not to nick, scratch or damage it during installation.
Cut the tube squarely with a sharp knife or tube cutter. Shake out and remove
any swarf and debris.
Ensure there is adequate ventilation available through the cupboard. If there is
inadequate ventilation, and the cupboard temperature rises to above 40°C, the
chiller may become damaged and malfunction which will void the product
warranty.
There must be a minimum 168cm2 of cupboard cross-flow ventilation.
Suitable holes or vents will need to be cut into the cupboard and door.
For safe operation, thoroughly flush the water through after non-use periods
longer than 12 hours.
Filter cartridges (if fitted) should be replaced at least every 6-12 months, or
sooner if you notice:
A. a persistent reduction in water pressure from the product, or;
B. an unpleasant taste or odour in the water.
Not changing the cartridges when required may cause the water to become
biologically unsafe.
Commissioning
Clip the tubing in the cupboard. After the appliance is installed and connected,
turn "ON" the water supply. Check all connections for leaks. Repair any
found.
The filters (if fitted), chiller and tubing are full of air until purged. Press the
operating lever on the appliance outlet tap for a minimum of five minutes until
all of the air has been purged from the system.
Plug the 3-pin power cord into a standard power point. Do NOT turn "ON"
until after the unit is purged.
Wipe clean and dry the area.
Dispose of packaging wisely.
# Domestic Installation Instructions continued
The use of this crossed out wheeled bin logo indicates that this product needs
to be disposed of separately to any other household waste.
Within each of the European Union member countries, provisions have been
made for the collection and recycling of unwanted electrical and electronic
equipment. Outside of the EU it will be necessary to dispose of this product at
your local community waste collection or recycling centre.
In order to help preserve our environment we ask that you dispose of this
product correctly. Please contact your local city council for collection centre
details
Loading ...
Loading ...
Loading ...