Loading ...
Loading ...
Loading ...
Fig. 13
u
On the top press the short cover strip
Fig. 13 (9)
into the
horizontal gap.
Fig. 14
u
On the front, press the long trim
Fig. 14 (10)
into the vertical
gap. Ensure that the strip rests on the connecting plate.
u
Peel the protective film off the cover strip.*
Fig. 15
u
Snap the top cover
Fig. 15 (11)
onto the still open gap
between the two control panel trims. Make sure that the
outer sides of the cover form a flush finish with the control
panel trims
Fig. 16
u
Place the bottom cover
Fig. 16 (12)
onto the bracket from
the front (1), slide it down (2) and snap it in at the bottom (3).
u
To disassemble the cover, insert a screwdriver at the bottom
on the side below the cover and release both lower hooks.
The cover can swing out towards the top.
u
Connect the combination to the mains according to the
manual.
Appliances with IceMakers:
u
Connect the appliance to the fixed water connection
according to the manual.
NOTICE
Risk of damage when moving the combined SBS appliance!
The combined SBS appliance is heavy once assembled. The
appliance may be dented by improper movement.
u
Observe the information given on moving the appliance (see
above).
u
Carefully slide the combination into the intended position.
u
If necessary, align the height with the height-adjustable feet.
u
Then support the door: Lower the adjustment feet on the
mounting block until they rest on the floor then turn a further
90°.
The doors can be aligned in
height with the aid of the outer,
lower turn hinges:
u
Extend the threaded pin
Fig. 17 (17)
a little (by one
turn at most!).
Fig. 17
Fig. 18
u
In order to lift the door unscrew the mounting block
Fig. 18 (18)
clockwise with the supplied open-end wrench
Fig. 18 (2)
. When delivered the mounting block is completely
screwed in.
u
Tighten the threaded pin
Fig. 17 (17)
again to secure the
bearing pin.
Side-by-side assembly
* Depending on model and options 5
Loading ...