Loading ...
Loading ...
Loading ...
SERVICE AND ADJUSTMENTS
/
"POSITIVE" (+) "NEGATIVE" (-)
IL°PANE;!
FiG. 27
_'O REPLACE HEADLIGHT BULB
Raisehood.
Pullbulbholderoutoftheholeinthebacksideofthe
grill.
Replacebulbinholderand push bulbholdersecurely
back intotheholeinthebacksideofthegrill.
C!ose nooq.
_NTERLOCKSAND RELAYS
LOOSeor damaged wiring may cause your tractor to run
uoorly, stop running, or prevent itfrom starting.
Check w_nng, See electrical wiring diagram in the
Repair Parts Section of this manual.
TO REPLACE FUSE
:_eulase with 30 amp automotrve-type plug-in fuse. The
fuse holder is ocated behind the dash.
'FO REMOVE HOOD AND GRILL ASSEMBLY
(See Fig. 28)
Raise hood.
Unsnap headlight wire connector.
Stand in front of tractor. Grasp hood at sides, tilt toward
engine and lift off of tractor.
To replace, reverse above procedures.
_HOOO
HEADLIGHT
WIRE
CONNECTOR
FIG. 28
ENGINE
TO ADJUST THROTTLE CONTROL CABLE
(See Fig. 29)
The throttle control has been preset at the factory and
adjustment should not be necessary. Check adjustment as
described below before loosening cable. If adjustment is
necessary, proceea as follows:
With engine not running, move throttle control lever to
fast (,_) position.
Check that swivel is against side of quarter circle. If it
s not. _oosen cable clamp screw and DUllcable back
until swive is against quar[er circle. Tighten cable
clamp screw securely.
QUARTER
CIRCLE-_
" SWIVEL
FIG. 29
24
TO ADJUST CHOKE CONTROL (See Fig. 30)
The choke control has been oreset at the factory and
adjustment should not be necessary. Check ad ustment as
described oelow before loosening cable. If adjustment is
necessary, proceed as follows:
Loading ...
Loading ...
Loading ...