Loading ...
Loading ...
Loading ...
23INSTALLATION
WARNING
ELECTRICAL SHOCK HAZARD
DO NOT make a sharp bend or crimp
wiring/conductor at connections.
IMPORTANT
If moving dryer from a 4-wire system
and installing it in a 3-wire system,
move the internal ground from the
center terminal back to the GREEN
screw next to the terminal block.
7. Follow manufacturer’s guidelines for
firmly securing the strain relief and
power cord.
8. Reinstall the terminal block cover.
6. Attach the remaining two power
cord outer conductors to the outer,
BRASS colored terminals on the
terminal block. Tighten both screws
securely.
1. Turn o power supply to outlet.
2. Remove the screw securing the
terminal block access cover on the
back of the dryer.
3. Install a UL-approved strain relief
according to the power cord/strain
relief manufacturer’s instructions in
the power cord entry hole below the
access panel. At this time, the strain
relief should be loosely in place.
4. Thread an UNPLUGGED, UL-
approved, 30 amp. power cord,
NEMA 14-30 type DRT or SRDT,
through the strain relief.
Neutral
(WHITE
wire)
30 AMP
NEMA 14-30
Ground
(GREEN
wire)
Electrical connection
(non-Canada) - 4-wire cord
5. Disconnect the internal (WHITE) dryer
harness ground wire from the
(GREEN) ground screw next to the
terminal block.
6. Attach the ground (GREEN) power
cord wire to the cabinet with the
ground (GREEN) screw. Tighten the
screw securely.
4-wire receptacle
(NEMA type 14-
30R)
WARNING
ELECTRICAL SHOCK HAZARD
Failure to disconnect power source
before servicing could result in personal
injury or even death.
Brass
Terminal
Brass
Terminal
DO NOT remove
internal ground in
a 3-wire system
Move Internal ground (WHITE) wire to neutral Move Internal ground (WHITE) wire to neutral
(SILVER) terminal for 4-wire system.(SILVER) terminal for 4-wire system.
BLACK or BLACK or
RED power RED power
wireswires
GREEN GREEN
ground ground
screwscrew
GREEN GREEN
ground wireground wire
BRASS
terminals
WHITEWHITE
internal internal
ground ground
wirewire
WHITEWHITE
Neutral wireNeutral wire
WHITEWHITE
Neutral wireNeutral wire
SILVER SILVER
TerminalTerminal
WHITE internalWHITE internal
ground wireground wire
7. Move the internal dryer harness
ground (WHITE) wire to the terminal
block and attach it along with the
neutral (WHITE) power cord wire
conductor to the center, SILVER
colored terminal on the terminal block.
Tighten the screw securely.
Loading ...
Loading ...
Loading ...