Loading ...
Loading ...
Loading ...
EN
©2020 Hestan Commercial Corporation
19
FINAL SETUP
Remove any final packaging materials, and protective film from all exterior areas. Check inside oven
for other packaging items, tape on oven racks, etc. Install any loose items like sealed burner heads,
cooking grates, etc. Ensure the sealed burner heads are properly installed and seated on the burner
base as shown below. There are notches on the burner base and cross ring to help with alignment.
The outer burner head features a long slot on the top of the head which aligns with the spark igniter.
Assembly of the single-flow burner head is similar.
Before testing operation of the appliance, verify the leak check was performed and the electrical
power has been restored to the unit. Turn the gas shut-off valve to the open position.
NOTICE
All the control knobs must be in the OFF position to prevent unintended operation at power up.
In the event of a power failure, the oven will shut off. The surface burners will continue to burn,
but must be ignited manually with suitable lighter or match. When the power is restored, the oven
will not operate until the oven knobs are in the OFF position. Set all the knobs to OFF, and resume
normal use.
DO NOT ATTEMPT TO USE THE RANGE DURING A PROLONGED POWER FAILURE.
Verify ignition at each burner. Igniter will make a clicking sound until the flame lights within 4
seconds, then the clicking will stop. Check flame characteristics at each burner per the descriptions
below. Flames should be stable and not dance or lift off the burner ports. Flame may need to burn
for a few minutes to purge the gas lines of impurities. These appear as intermittent orange tips or
even tiny sparks in the flame. This is normal and the flame will eventually stabilize like those shown
in the image below.
If after a few minutes the flames continue to burn mostly yellow, verify that the burner head is
properly installed on top of the base, then retest. Use caution when handling the burner head. They
can be very hot.
BURNER
RING
BURNER
HEAD
BURNER
BASE
IGNITER
INNER
BURNER
HEAD
OUTER
BURNER
HEAD
BEAUTY
RING
CROSS
RING
BURNER
BASE
DUAL FLOW
BURNER
SINGLE FLOW
BURNER
Loading ...
Loading ...
Loading ...