Loading ...
Loading ...
Loading ...
• i ,11111 ii ii i,illUi i ii i , iiirlii i i HllUUIII II1'1'11111'1 III II I I I
ASSEMBLY
11111 ,Rrlllllll illUl,ii iiii iiii i ,,, ,,,,,,,,,,,,, u i,i ',Hill ii iiii I lUl I iiiiiiiiiiiii
Your new tractor has been assembled at the factory with exception of those parts left unassembted for shipping purposes.
To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use
the correct tools as necessary to insure proper tightness.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set wittmake assembly easier. Standard
wrench sizes are listed.
(1) 5/16" wrench
(2) 7/16" wrenches
(1) 1/2" wrench
(1) 9/16" wrench
(!) 3/4" Socket w/dnve rachet
Phillips Screwdriver
Tire pressure gauge
Utility knife
When right or left hand is mentioned in this manual, it
means when you are in the operating position (seated
behind the steering wheel).
TO REMOVE TRACTOR FROM CARTON
UNPACK CARTON
• Remove all accessible loose parts and parts cartons
from carton (See page 6),
• Cut, from top to bottom, atong lines on atl four comers
of carton, and lay panels fiat.
° Check for any additional loose parts or cartons and
remove.
BEFORE ROLLING TRACTOR OFFSKID
ATTACH STEERING WHEEL (See Fig, 1)
- Slide the steering bushing over the steenng shaft.
. Raise steering shaft forward until screw holes in dash
line up with steering bushing. Install two (2) sheet
metal screws and tighten securely.
• Posit{on steering boot over steering shaft.
• Ptace tabs of steering boot over tab slots in dash and
push down to secure,
• Slide steering wheel adapter onto upper steedng shaft.
, Position front wheels of the tractor so they are pointing
straight forward.
, Position steering wheel so cross bars are horizontal
(left to right) and siide onto adapter.
• Assemble large flat washer and 3/8-24 iocknut and
tighten securely.
• Snap steering wheel insert into center of steering
wheel.
• Remove prote_ive ptast_c from tractor hood and grill.
IMPORTANT:CHECK FOR AND REMOVE ANY STAPLES
IN SKID THAT MAY PUNCTURE TIRES WHERE TRACTOR
tS TO ROLL OFF SKID.
BUSHING
SCREW'
PosmoN)
F]G. t
SLOT
TO ROLL TRACTOR OFF SKID (See Fig. 8)
Raise attachment lift tever to its highest position.
• Release parking brake by depressing clutch/brake
pedal.
• Place gearshift lever in neutral (N) position.
• Rotl tractor backwards off skid,
• Remove banding holding discharge guard up against
tractor.
Loading ...
Loading ...
Loading ...