Loading ...
Loading ...
Loading ...
8
MAINTENANCE
- Always unplug from the outlet before cleaning.
- During the season when the appliance is in use, clean
the air intake and outlet grilles regularly using a vacuum
cleaner.
- To clean the lter, remove the rear grille by pulling it
outwards (g. 1). Remove the dust lter that retains
impurities in the air drawn in from the room, blow on it
lightly then put it back in the appliance.
- Never use abrasive powders or solvents to clean the
appliance.
Safety functions
- Safety device: the appliance is tted with a safety
device that switches it o in the event of accidental
overheating (e.g. obstruction of air intake and outlet
grilles, motor turning slowly or not at all). To reset,
unplug the appliance from the outlet for a few minutes,
remove the cause of overheating, then plug in again.
- Tip-over safety device: a tip-over safety device
turns the appliance o if it falls over or is positioned
inappropriately in such a way as to jeopardize safety.
The appliance emits a beep and a dot ashes on the
display. The appliance resumes operation a few seconds
after being placed in an upright position again.
TECHNICAL CHARACTERISTICS
Power supply See rating plate
Absorbed power “
PROBLEM CAUSE SOLUTION
PF display
Temperature sensor is not working
properly
The product needs to be serviced, contact
our toll free number for assistance
Product doesn’t turn on Check that the plug is connected to the
outlet
Auto-start is on
Room temperature reaches the set
temperature
Plug in
Wait till time elapsed or press the but-
ton (E) twice to cancel the auto-start
and push the button (A)
Use the “+” button to increase the set
temperature
A green dot is ashing and unit is o The tip-over switch has been activated Make sure the appliance is standing
upright on a at surface, if the problem
persists contact our toll free number to
assist you
TROUBLESHOOTING
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in
a particular installation. lf this equipment does cause
harmful interference to radio or television reception, which
can be determined by turning the equipment o and on,
the user is encouraged to try to correct the interference by
one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
receiver.
- Connect the equipment into an outlet on a circuit
dierent from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV
technician for help.
Modications not approved by the party responsible
for compliance could void user’s authority to operate
the equipment.
CAN ICES-3 (B) / NMB-3 (B)
Loading ...