Loading ...
Loading ...
Loading ...
Troubleshooting
PROBLEM PROBABLECAUSE CORRECTIVEACTION
EngineWill Not Start 1. Fueltank empty. 1. Fill fuel tank with fresh fuel.
2. Spark plug wire disconnected. 2. Placespark plug wire onto spark plug.
3. Wiring harnessdisconnected. 3. Connectwiring harness.
4. Battery dead. 4. Chargeor replacebattery.
EngineStalls or Loses 1. Blade control is releasedor is not being held 1. Bladecontrol should be held securely against
Power After Running securely against drive control, drive control at all times during operation.
2. Fueltank empty. 2. Fill with fuel to proper level.
3. Engine pre-cleaner and/or air cleaner dirty. 3. Cleanor replaceprecleaner and/or air cleaner.
4. Spark plug fouled or gap set improperly. 4. Service spark plug.
5. Water, debris or stale fuel in fuel system. 5. Drain and clean fuel system.
ExcessiveVibration 1. Damaged,out of balance or bent mower blade.1. Contactauthorized dealer.
2. Loose blade components. 2. Contact authorized dealer.
3. Loose or missing air lift (if equipped). 3. Contact authorized dealer.
4. Lumpy or frayed belt. 4. Contact authorized dealer.
Mower Will Not Move/ 1. Build-up of debris on or around drive 1. Cleandebris.
Loss Of Traction components.
2. Transmission cable adjustment required. 2. Adjust transmission cable.
3. Drive belt requires replacement. 3. Contactauthorized dealer.
4. Damagedtransmission. 4. Contact authorized dealer.
Cutting Grass improperly 1. Cutting height too low or high. 1. Adjust cutting height.
2. Forward speed too fast. 2. Adjust to a slower speed.
3. Cutting blade dull or damaged. 3. Contact authorized dealer.
Poor Grass Discharge 1. Forward speed too fast. 1. Adjust to a slower speed.
2. Grass is wet. 2. Mow when grass is dry.
3. Excessivelyworn or damaged blade. 3. Contact authorized dealer.
4. Build up of grass clippings and debris under 4. Cleandeck.
deck.
5. Improper blade installed on deck. 5. Contact authorized dealer.
6. Blade installed improperly on deck. 6. Contact authorized dealer.
Oil Leaking 1. Loose dipstick. 1. Make sure dipstick/oil filler cap is securely in
)lace.
2. Loose drain plug. 2. Checkand tighten drain plug.
3. Oil level is overfilled. 3. Drain excess oil.
4. Damagedoil seals. 4. Contact authorized dealer.
20 www.snapper.corn
Loading ...
Loading ...
Loading ...