Loading ...
Loading ...
Loading ...
8. SETTING THE GENERATOR
FIG.7
FIG.8
8.5
STARTING THE GENERATOR - FIGS. 7 - 10
Step1: Turn on the fuel tap (Fig.7).
Step 2: Turn on the engine switch (Fig.8).
Step 3: Move choke lever to the start (closed )
position. The choke may not be needed if the
engine is warm.
Step 4: Pull slowly on the starter cord until it
engages. Then pull sharply to start the engine
(Fig.10).
Step 5: If starting from cold allow the engine to run
with no load for a few minutes to allow the
engine to warm up.
Step 6: Move the choke lever to the open
(to the right) position.
8.6 STOPPING THE GENERATOR
Step 1: Unplug all appliance power cords.
Step 2: Turn the engine switch to off.
Step 3: Turn the fuel tap to the off position.
8.7 CONNECTING APPARATUS TO THE
GENERATOR
1. Start the engine. Allow the motor to run for a
couple of minutes to warm up prior to connecting
any apparatus to the generator.
2. For AC current ensure the AC circuit breakers are in
the “OFF” position.
3. Ensure correct voltage is selected, then plug power
cord into AC output socket.
4. Switch the AC circuit breakers to the “ON”
position.
NOTE: There are 2 voltages - please ensure correct
voltage is selected.
CAUTION: Ensure the electric apparatus is turned off
before plugging in.
Check to ensure that the total load is within the
generator rated output.
Ensure circuit breaker is in ‘ON’ position.
For DC current plug into the DC outlet socket. Only use
a DC plug to charge lead acid type batteries. Do not
charge Ni-cad or any other type of batteries.
FIG.9
FIG.10
13
Loading ...
Loading ...
Loading ...