Loading ...
Loading ...
Loading ...
8. SETTING THE GENERATOR
8.1 AUTOMATIC VOLTAGE REGULATOR
(AVR)
This generator has been equipped with AVR
technology which provides automatic voltage
regulated power for continuous uninterrupted stable
power supply.
The AVR maintains a regulated AC output and reacts
substantially quicker to rapid surges in voltage,
therefore, preventing the possibility of damage to the
generator and attached equipment.
For sensitive equipment please ensure you protect
with relevant surge protection equipment.
8.2 PREPARING THE GENERATOR - FIGS. 1 - 4
It is important to check the generator before you
commence operating the unit.
IMPORTANT: Ensure that the engine has oil. When
leaving the factory, this generator has NO OIL in the
engine; remove cap/dipstick and fill with the
recommended engine oil.
NOTE: The generator has a low oil sensor and will not
start if the generator has no oil (Fig.1).
8.3 FUELLING
Use unleaded petrol only.
1. Remove the petrol cap .
2. Ensure the fuel filter is in place - Do not pour fuel
into the tank without the fuel filter in place.
3. Do not over fill - leave air gap at top of fuel level.
4. Always screw down fuel cap.
5. Clean up any spilled fuel immediately.
6. Move generator at least 12 feet (4M) away from
the fuelling area before starting.
WARNING:
• Do not refill fuel tank while engine is running or is
hot.
• Check to ensure that the fuel drain has been
tightened and that fuel is not leaking.
• Be careful not to admit dust, dirt, water or other
foreign objects into the fuel.
• Wipe off spilt fuel thoroughly before starting
engine.
• Ensure you DO NOT fuel the generator in close
proximity to any open flames.
FIG.2
FIG.1
FIG.3
FIG.4
11
Loading ...
Loading ...
Loading ...