Loading ...
Loading ...
Loading ...
7
5. Unscrew and remove the 2 x screws that hold down the door locking mechanism.
6. Remove the plastic caps next to the locking mechanism.
7. Swap the door locking mechanism and hinge over to the opposite side and then screw
them in place. Do not completely tighten just yet.
8. On the base of the cabinet unscrew and remove the 4 x screws that hold down the
hinge.
9. Unscrew and remove the 4 x screws that hold down the door guide.
10. Swap the door guide and hinge over and then screw them in place.
11. Proceed to tighten all the screws.
Handy Tips:
• If there are any gaps in the door seal, use a hairdryer to gently heat the door seal and
make it so. This will allow it to take shape of the fridge and seal again. Leave the door
seal closed for 30 minutes so it can cool down and take shape.
• Once you’ve stood the fridge back up and the door seal feels tight (on the hinge side),
spray it with a silicon base spray or use a thin layer of Vaseline. This will help the seal
slide and not roll over.
Warning: Do not use a cordless screwdriver to reattach the screws as you may cross
thread the screws and damage the thread. Always start the thread with a handheld
screwdriver.
Installing the Mounting Kit
*This product is not included and can be purchase separately via our website.
The mounting kit consists of the following:
• 1 x top piece – which allows for the door to be le or right opening
• 2 x side pieces
• 4 x screws
• 4 x washers
Each piece included in the mounting kit contains pre-drilled holes. These pre-drilled holes
are the ONLY place the mounting kit should be attached, failure to do so may void the
warranty of the fridge.
When drilling into the cabinet, use a drill-stop to ensure the drill bit does not pierce the
outer skin of the cabinet. We also suggest that it is fitted within the first 50mm of the front
of the cabinet.
Once attached, it adds an additional 25mm to the height and 50mm to the width (25mm
each side) of the cabinet.
Loading ...
Loading ...
Loading ...