Loading ...
Loading ...
Loading ...
CLEANING
IMPORTANT: For best performance, keep
mower housing free of built-grass and
trash. Clean the underside of your mower
after each use.
,&CAUTION: Disconnect spark plug wire
from spark plug and place wire where it
cannot come in contact with plug.
o Clean the underside of your mower by
scraping to remove build-up of grass/trash.
O
o
Clean engine often to keep trash from
accumulating. A clogged engine runs
hotter and shortens engine life.
Keep finished surfaces and wheels free
of all gasoline, oil, etc,
We do not recommend using a garden
hose to clean lawn mower unless the
electrical system, muffler, air filter and
carburetor are covered to keep water
out. Water in engine can result in short-
ened engine life.
,&WARNING: To avoid serious injury, before performing any service or adjustments:
to Release control bar and stop engine.
2, Make sure the blade and all moving parts have completely stopped°
3. Disconnect spark plug wire from spark plug and place wire where it cannot come in
contact with plug.
LAWN MOWER
TO ADJUST CUTTING HEIGHT
See "TO ADJUST CUTTING HEIGHT" in
the Operation section of this manual.
REAR DEFLECTOR
The reardeflector, attached between the rear
wheels of your mower, is provided to minimize
the possibility that objects will be thrown out
of the rear of the mower into the operator's
mowing position, tf the deflector becomes
damaged, it should be replaced.
DISCHARGE GUARD
The discharge guard, attached to the
discharge opening of your lawn mower, is
provided to prevent the possibility of injury
resulting from objects being thrown out of
the discharge opening into the operator
mowing position_ if the discharge guard
becomes damaged, it should be replaced.
TO ADJUST HANDLE
The handle can be mounted in a high or
low positiom The mounting holes in the
bottom of lower handle are off center for
raising or lowering the handle.
1. Remove upper handle and all wire
tie(s) securing cable(s) to lower handle.
2. Remove hairpin cotters from lower
handle bracket mounting pin.
3. Squeeze lower handle in to remove it
from mounting pins_
4, Turn lower handle over to raise or lower
handle_
5. Squeezelowerhandleinandpositionholes
onto mounting pins on handle bracket,
6. Reassemble upper handle and all parts
removed from lower handle. 13
SQUEEZE
TO ADJUST
Lowe
Mounting
Hairpin cotter
Mowing
cotter ,_.
Mountlng"t
pin
r"q Mowing _-_.
i _ position / ,/
,,;
, \ v'-." I I
_" W-bracke t ---
=1
LOW POSITION HIGH POSITION
\-\
Lower __
,°ndle S,
oo \\
Loading ...
Loading ...
Loading ...