Loading ...
Loading ...
Loading ...
GRASS CATCHER
(If purchased as an accessory)
o The grass catcher may be hosed with
water, but must be dry' when used_
o Check your grass catcher often for dam-
age or deterioration, Through normal
use it wilt wear. If catcher needs replac-
ing, replace only with approved replace-
ment catcher shown in the Repair Parts
section of this manual. Give the lawn
mower model number when ordering.
ENGINE
LUBRICATION
Use only high quality detergent oil rated with
API service classification SG-SL. Select the
oil's SAE viscosity grade according to your
expected operating temperature,
SAE vtscosrP( GRADES
Ii mlmlm _ iilIINI_
C .,3,0 '_ .TO 0 t0 20 30 40
TEMPERATURE RANGE ANTICIPATED BEFORE NEXT OIL CHANGE
NOTE: Although multi-viscosity oils (5W30,
10W30 etc.) improve starting incold weather,
they will result in increased oil consumption
when used above 32°E Check your engine
oil level more frequently to avoid possible
engine damage from running tow on oil.
Change the oil after every 25 hours of opera-_
tion orat least once a year if the lawn mower
is not used for 25 hours in one year.
Check the crankcase oil level before
starting the engine and after each five (5)
hours of continuous use. Tighten oil plug
securely each time you check the oil level.
TO CHANGE ENGINE OIL
1. Disconnect spark plug wire from spark
plug and place wire where it cannot
come in contact with plug.
2. Be sure lawn mower is on level surface°
NOTE: Oil will drain more freely when
warm. Catch oil in a suitable container.
3. Remove bottom oil drain plug.
4. After oil has drained completely, replace
oil drain plug and tighten securely.
5. Fill engine with oil. (See "ADD OIL" in
the Operation section of this manual).
6. Reconnect spark plug wire to plug.
AIR FILTER
Your engine will not run properly and may
be damaged by using a dirty air filter°
Clean the element after every 25 hours
of operation or every season, Replace
the air filter every 100 hours of operation
or every season, whichever occurs first.
Service air cleaner more often under dusty
conditions.
TO CLEAN AIR FILTER ELEMENT
1. Remove screw,
2. Remove air cleaner carefully to prevent
dirt from entering carburetor.
3. Take air cleaner apart and clean air
filter element.
4. Wash filter element in liquid detergent
and water.
5. Wrap filter element in cloth and
squeeze dry°
6. Lightly coat filter element with clean
engine oil. Squeeze in towel to remove
excess oil. Do not saturate.
7. Reassemble parts and put back on
carburetor,,
Screw ASSEMBLE ONE OF THESE LOW POINTS
TOWARDS NARROW EDGE OF ELEMENT
Lip Element
ASSEMBLE SO LIP
EXTENDS OVER
EDGE OF
AIR CLEANER
BODY
LIP WILL FORM
PROTECTIVE
SEAL WHEN
COVER IS ASSEMBLED
MUFFLER
Inspect and replace corroded muffler as it
could create a fire hazard and/or damage.
SPARK PLUG
Replace spark plug at the beginning of
each mowing season or after every 100
hours of operation, whichever occurs
first. Spark plug type and gap setting
are shown in the "PRODUCT SPECIFfC_
12 ATIONS" section of this manual.
Loading ...
Loading ...
Loading ...