Loading ...
Loading ...
Loading ...
6.5 Before twisting the housing cap back on, make sure the O-ring is seated at the end of the
membrane housing as shown in figures 8 and 9. This is very important to avoid leaking
and damages to the O-ring.
6.6 Place the membrane housing cap back on and hand tighten it, then use the housing wrench
to tighten it another ¼-½” of a turn. Do not over tighten.
6.7 DO NOT reconnect the tubing to the fitting on the cap at this point (will be done in system
start up).
Step 7: Tubing Hook Up (see figure 5 above to see letters not shown below)
Page 11 www.123filter.com | (678) 261-7611 | [email protected]
Loading ...
Loading ...
Loading ...