Loading ...
Loading ...
Loading ...
Step 2: Installing the RO Faucet
2.1 If your kitchen sink does not
have an existing 1/2 inch
faucet hole, you will have to
drill one. (Refer to How to
drill a Hole on Sink or
Counter-top). Wipe clean and
dry the area.
2.2 Slip the front plate on the
faucet stem, followed by the
rubber washer. Insert the
faucet stem into the hole on
the countertop. Under the sink,
slip on the back rubber washer,
and tighten the nut with the
plastic wing.
2.3 Slide the quick connect fitting
up the push-in adapter on the
base so that it seats securely
into the faucet stem, then lock
it in place by sliding the blue
clip under the collet.
2.4 Insert the BLUE tubing about
1/2 inch into the push-in
fitting, and again, secure it with the blue clip.
Step 3: Installing the Drain Saddle
3.1 Choose a spot on the drain pipe that is convenient for installing the drain saddle and tubing.
A horizontal pipe is recommended to minimize the dripping sound.
3.2 Drill a 1 /4 inch hole in the drain pipe, and paste the black sticky pad around the hole.
3.3 Cut the WHITE tubing end to make a 45 degree angle. Slip the plastic nut and front plate
on the tubing. Insert the tubing into the 1 / 4 inch hole in the drain pipe, install the back
plate, and tighten the two screws with hex nuts while the tubing remains in the hole. Insert
Lock Clip. Pull the tubing lightly to make sure it is secure.
3.4 Tighten the nut on the Drain Saddle by hand. Pull the tubing lightly to make sure it is
secure.
Page 9 www.123filter.com | (678) 261-7611 | [email protected]
Loading ...
Loading ...
Loading ...