Loading ...
Loading ...
Loading ...
36 www.westinghouse.com.au / www.westinghouse.co.nz
Connect the water inlet hose to a tap
with 3/4” BSP thread.
When installing this washing machine,
use the hoses supplied. DO NOT USE
OLD HOSES. The inlet hoses have the
sealing washer fitted.
Install the machine on a flat hard floor.
Make sure that air circulation around the
machine is not impeded by carpets, rugs
etc. Check that the machine does not
touch the wall or cupboard units.
When the washing machine is levelled,
try to rock it from corner to corner. If it
does rock, adjust the legs again until it is
levelled and does not rock.
Turn the taps on and check that there are
no leaks from the connections.
Turn off the water taps and move the
washing machine into its final position.
Make sure that the inlet and drain hoses
do not kink.
Connect the inlet hose to the water tab.
Make sure the connections are tight.
It is important that your washing machine
stands firm and level on the floor to
ensure correct operation.
Use a spirit level on the front and side
panels of the washing machine to check
the levels. The spirit level should be used
close to the corners of the washing
machine for accuracy. By hand, or using
a spanner if necessaryDGMXVWWKHEDFN
OHJVILUVWWKHQWKHIURQW
$GMXVWWKHIRXUOHJVXSRUGRZQDV
UHTXLUHG You machine may have
adjustable legs with a stepped base. If
so, please use either a 38 mm or 25 mm
spanner or adjust them by hand.
Water Tap
Inlet hose
Filter and
rubber washer
inside nut.
If you do not have spirit level, as a guide
use the edge of a door frame, cupboard
or bench to check that the washing
machine is level.
Never place cardboard, wood or similar
materials under the machine to
compensate for any unevenness in the
floor.
10.3 Water Inlet
10.2 Positioning
Loading ...
Loading ...
Loading ...