Loading ...
Loading ...
Loading ...
A
Assembly (continued)
Mounting the Table Trunnion Support
From lhe _eose par_s find the following items:
_om
A
B
C
D
E
Description Qty.
M8 x 35 he× head bolts (approx. t--3/8 _) .............. 2
M8 Iockwashers ................................................ 2
M8 x 80 hex cap bolt ........................................... 1
(table stop boll appro×. 3-1/8' long)
M8 nut dor table slop bolt) ................................... t
Table lrur_nlon support (shown below} ................. 1
C
I I i -- _,
2. Attach trunnion support to saw body with two hex head
bolls and two lockwashers as shown
3, Thread nut (C) onto table stop bolt (D) and attach to
trunnion support.
E ' ' ' ["!"[(!!!["' ' II I IIIIi .......
Mounting the Table
t, From the loose parts find the following items:
_em Description Qty.
A Table i
B Knobs 2
A
[1111111 !llq' I [ I I I' I IJ I I_ ' ' IIII II" ii , I
2, To mount table, remove table insert and tat)le pin from
the tabte_ Guide sawblade through slot in table and
place table screws into trunnions,. Attach and lock with
lock knobs,
WARNING: Unit is shipped with blade in stalled.
Do not plug in or operate unit unless the blade
is adjusted and aligned per section titled
changing blades.
3 Reptace table insert and table pin,
4. Transportation and handlirtg may have caused some
fasteners to loosen. Before operating, check all
screws bolts and nuts to make sure they are snug.
Operate machine only after reading the entire manual
including blade tracking, blade guide adjustments, and
safety rules,
L
B
14
Loading ...
Loading ...
Loading ...