Loading ...
Loading ...
Loading ...
1. Basic Setup and Operation 7
The STATUS Indicator
Key O Off @ Steady On
O Slow Blinking Q Fast Blinking
None O TVis powered off, Norma) operation.
Green O TVis powered on, Norma) operation.
Green
Green
Yellow
Red
Red/ _D
Yellow
Tv powered off, auto-on TV Timer is
set,
Norma) operation. TV can be turned on
at any time.
TV just powered off and mampis
cooling.
Sixty seconds after turning off TV, LED
wiU start to bunk. TV can be turned back
on before bunking starts or after bunk-
ing stops, but not whUe the indicator is
bunking. Norma)operation.
TV is too hot. The TV wUIdisplay a
warning message and shut off if it over-
heats.
o Ambient room temperature may be
too high. Turn off the TV and let the
room temperature drop.
Clear blocked air vents. Ensure at
least a four-inch clearance on all
sides of the TV.
Lamp access door is not secure or no
(amp installed.
TV wiU not operate until lamp access
door is secured. See Appendix A.
Lamp faimureo Replace the lamp. See
Appendix A.
TV may require service.
* Hold power button on front panel for
10 seconds to reset TV.
* If LED continues to flash red and
yellow after reset, turn off the TV and
unplug it from the AC power source.
Wait one minute and then plug the
set back in.
If LED continues to flash red and
yellow, go to www.mitsubishi-tv.com
or call 1-800-332-2119 to receive
Authorized Service Center informa-
tion.
You may be asked to count how
many times the LED flashes each
color to aid in troubleshooting.
Setting Up and Using TV
Using the ANT (Antenna} Input
If using an antenna or direct cable service (no cable
box), connect the incoming coaxial cable to the TV's
ANT input. Refer to page 12.
You must perform a channem scan to enabme recep-
tion of digitam channemso mfyou skip this step, the TV
will receive onmy anamog channems. The channel scan
will search for high-definition and standard-definition
channels avaUable in the local area.
Memorizing Channels with ChanneY Sca n
For the ANT input
To start channem memorization
1, Power on the TV.
Press MENUand open the Setup > Channel menu.
First press V to navigate to the Setup icon, then
use _ to highlight the Channel icon.
Start channel memorization from the Setup > Channel
menu.
°
4°
Press V to enter the menu.
Highlight Ant Air if connected to an
over-the-air antenna. Highlight Ant
Cabmefor service over direct cable
(no cable box). Press ENTERto add a
check.
For first-time setup, highlight AH
channems. To scan for channels not
already in memory, highlight New
onmy. Press ENTERto add a check.
Highlight Scan and press ENTER.
Channel memorization may take up
to 15 minutes to complete.
To stop channem memorization before compmetion,
press CANCEL.
For assistance ca((1(800} 332-2119
Loading ...
Loading ...
Loading ...