Loading ...
Loading ...
Loading ...
Quick Start Guide
12 STAGEPAS 600BT/STAGEPAS 400BT Owner’s Manual
Connecting microphones, instruments, and audio
devices to the mixer
4. Connect desired devices, such as a microphone, or an instrument to the input
jack of the mixer.
Refer to the illustration on the mixer shown below or the connection example of the
cover panel of the accessory compartment.
Getting sound out of the system
5. Connect the included power cord as described in the steps below: Before
connecting the power cord, make sure that the power to the STAGEPAS is
turned off.
5-1 Connect the plug on the included power cord to the AC IN jack on
the rear panel of the unit.
5-2 Connect the other end of the power cord to a power outlet.
NOTE
To disconnect the power cord, reverse these steps.
Warning
The STAGEPAS has been designed for grounded use. To avoid electrical shock and damage
to devices, be sure to ground the unit using the included power cord. If you have any
questions regarding connections, contact your nearest Yamaha dealer.
Warning
Use only the included power cord. Otherwise, heat may be generated or electrical shock may
be caused.
Notice
Even when the power switch is turned off, a minimal amount of electric current is still flowing
to the unit. If you plan not to use the unit for an extended period of time, be sure to unplug the
power cord from the AC outlet.
6. Turn the mixer’s LEVEL controls (white knobs) and MASTER LEVEL control
(red knob) to the minimum (zero).
Also, set the equalizer controls (green knobs) to the center “D” or “MUSIC”
position.
Equalizer
Loading ...
Loading ...
Loading ...