Loading ...
Loading ...
Loading ...
USING THE WOOD FACING ON THE
RIP FENCE (Fig. as)
When performing some special cutting
operations, you can add a wood facing
to either side of the rip fence (2).
1. Use a smooth straight 3/4 in. thick
wood board (1) that is as long as the
rip fence.
2. Attach the wood facing to the
fence with wood screws (3) (not
included) through the holes in the
fence. A wood fence should be used
when ripping material such as thin
paneling to prevent the material from
catching between the bottom of the
fence and the table.
Fig. aa
To avoid the risk of personal
injury. Always use push block,
auxiliary fence and featherboard
when making non4hrough cut.
1. Before starting the table saw, lower
the blade and riving knife assembly
to the down position.
2. Remove the blade guard assembly
and anti-kickback pawls assembly
for non-through cut.
3. Use the featherboard (1) with
C-clamps (3) to fasten the
workpiece securely.
4. Mount the auxiliary fence (4) with
C-clamps.
5. Use the push block (2) to move the
workpiece.
NOTE:
o Mount the featherboard to table
as shown, so the leading edges of
featherboard will help workpiece
complete cutting.
Fig. bb
NON-THROUGH CUT (FIG. bb) ....: _
A non-through cut is used to cut
/
grooves and rabbets in the workpiece / ".
without exposed the blade. :'
Non-through Cut
i_ WARNING i
4
o Only this type cut is made
without installing the blade guard
assembly, anti-kickback pawls
assembly.
o To avoid injury from an accidental 2
start, make sure the switch is in
the OFF position and the plug
3 1
is disconnected from the power
source outlet.
Loading ...
Loading ...
Loading ...