Loading ...
Loading ...
Loading ...
.
.
Place the front of assembly into the
back slot on the riving knife and
push downward. Release the locking
knob. Make sure the lock knob is
engaged in the hole and that there is
no movement of the assembly.
(Fig. Z)
Fig. Z
Take the blade guard assembly and
locate the red sliding locking knob
(3) on the back of assembly.
(Fig. AA)
Fig. AA
6
5. Insert the blade guard assembly
onto the riving knife so that the pin
(4) engages into slot (5) completely.
(Fig. BB)
6. Slide the red locking knob (3) up
and press the guard assembly down
so that the entire assembly is flat on
the riving knife. Release the locking
knob (3).
7. Make sure that the assembly is locked
in place both in front and back.
Fig. BB
5
4
Removing the blade guard and
anti-kickback pawl assembly
(Fig. Z, BB)
I,,_ WARNING]
To avoid injury from an accidental
start, make sure the switch is in
the OFF position and the plug is
disconnected from the power source
outlet.
1. With the blade elevation handwheel
raise the blade to the maximum
height.
2. Loosen the blade lock handle and
then turn the handwheel to 45° on
the bevel scale.
3. Tighten the bevel lock handle.
4. Remove the anti-kickback pawl
assembly by pressing up on the red
knob (2) and lifting the assembly off
the riving knife. (Fig. Z)
5. Remove the blade guard assembly
by pressing up on the red knob
(3) and lifting the assembly off the
riving knife. (Fig. BB)
27
Loading ...
Loading ...
Loading ...