Loading ...
Loading ...
Loading ...
1.Removethemitergaugeandstoreit
inthe"storage"compartmentinthe
baseofthesaw.
2. Securetheripfencetothetable.
3. Raisethebladesoitisabout1/8in.
higherthanthetopoftheworkpiece.
4. Placetheworkpieceflatonthetable
andagainstthefence.Keepthe
workpieceawayfromtheblade.
5.TurnthesawONandwaitforthe
bladetocometofullspeed.
6. Slowlyfeedtheworkpieceintothe
bladebypushingforwardonlyonthe
workpiecesection(1)thatwillpass
betweenthebladeandthefence.
(Fig.PP)
7. Keepyourthumbsoffthetabletop.
Whenbothofyourthumbstouchthe
frontedgeofthetable(2),finishthe
cutwitha pushstick(3).Tomakean
additionalpushstick,usethepattern
onpage47.(Fig.PP)
WARNING I
AVOID KICKBACK by pushing
forward on the section of the
workpiece that passes between the
blade and the fence. Never perform
any freehand operations.
Fig. PP
6
WARNING]
When width or rip narrower than
2 in. the push stick cannot be
used because the blade guard will
interfere. Use the auxiliary fence (4)
and push block (5) as shown.
(Fig. QQ)
Fig. QQ
7
8. Continue pushing the workpiece (6)
with the push stick (3-Fig. PP) or
push block until it passes through
the blade guard and clears the rear
of the table. (Fig. QQ)
9. Never pull the piece back when the
blade is turning. Turn the switch
OFF. When the blade completely
stops, you can then remove the
workpiece.
l,_ WARNING J
Never attempt to pull the workpiece
backwards during a cutting
operation. This will cause kickback
and serious injury to the user can
occur. When the blade completely
stops, raise the anti=kickback pawls
(7) on each side of the riving knife
and slide the workpiece out.
Loading ...
Loading ...
Loading ...