Loading ...
Loading ...
Loading ...
OPERATING
ADJUSTING CUTTING HEIGHT
1. Depress the lock button on Deck Lift Lever shown
in Figure 12 and pull lever backward to go to higher
cutting height or push lever forward to go to lower
cutting height. Release button to lock at new setting.
2. The six cutting height positions provide a range of
from 1-1/4" in low setting up to 3-3/4" in highest,
DEPRESSLOC_
BUTTON
!
UFT LEVER
(6 PosmoNs -
1.114" to 3.314")
HIGHEST,_
CUT
_J_ LOWEST
CUT
INSTRUCTIONS
RAISING CHUTE DEFLECTOR
(For Clearance Through Gates or
For Transporting Tractor).
1. Remove wing-nuts and flat washers (if used)
securing the Chute Deflector to the deck. See
Figure 13.
2. Raise Chute Deflector and re-install flat washers
and wing-nuts onto deck studs to prevent loss.
3. Transport the tractor to the desired location,
4. Be sure to return the Chute Deflector to the down
position and secure it to the deck before mowing.
__WING.NUTS
FIGURE 12
TIPS ON MOWING
FOR BEST RESULTS, USE THE FOLLOWING TIPS
WHEN MOWING:
When mowing, cut only 113 off of grass height.
Cutting grass deeper could be harmful to your
lawn.
If cutting extremely tall grass, make one cutting
with the deck in its highest cutting position, then
lower the deck to desired position and make a
second cut.
Mow when lawn is dry for best cutting.
Mow often. Shorter grass clippings decompose
more quickly.
Keep mower blades sharp. A dull blade tears and
shreds grass instead of cutting. Refer to "MOWER
BLADE SERVICE" in the Maintenance Section.
Alternate the mowing pattern every other time to
reduce the possibility of grass matting.
Mow with engine speed control in FAST and
ground speed control handle in a SLOW position.
Clean deck, removing all grass clippings and debris
from the top and underside of deck after each use.
CHUTE DEFLECTOR
(42" Cutting Deck)
FIGURE 13
A WARNING A I
Never attempt to operate mower without chute I
deflector secured in the down position! I
\
10
CHUTE DEFLECTOR
(48" Cutting Deck)
Loading ...
Loading ...
Loading ...