Loading ...
Loading ...
Loading ...
Installing the appliance
Songe
Bottom view
The thickness of the sponge is
The width of the sponge is
of the screws.There are one set of screw holes in each
corner of the hob(H).
Slightly tighten a screw(C) through the bracket(B) so
that the bracket is attached to the hob, but so that you
can still adjust the position
.
.2
Carefully turn the hob back over and then gently lower
it into the aperture hole that you have cut out.
.3 On the underneath of the hob, adjust the brackets into
a position that is suitable for your worktop.
Then fully tighten the screws(C) to secure the hob into
position.
3 mm.
6 mm.
appliance upside down and place it on a
cushioned mat.
supervision devices are not damaged
in this operation.
2.
Apply the sponge provided around the
edge ofthe appliance.
3.
1
3ODFHWKHEUDFNHW%RYHUWKHKROHVWKDWPDWFKWKHVL]H
7KLVZLOOPDNHLWGLI¿FXOWWRUHPRYHWKH
DSSOLDQFHIURPWKHDSHUWXUHLQIXWXUH
SDUWLFXODUO\LILWQHHGVWREHVHUYLFHG
o not use a siicon seaant to sea te
aiance aainst te aerture
IPTNT dditional to the sponge
around the edge of the appliance ensure
an additional strip is applied on each side
as per the diagram.
.
Loading ...
Loading ...
Loading ...