Loading ...
Loading ...
Loading ...
[ WAR"ING1
AVOID DIRECT EYE CONTACT
A Laser light is radiated when the laser guide is turned
on. Avoid direct eye contact. Always un-plug the
drill press from the power source before making any
adjustments.
, A laser pointer is not a toy and should not come into
hands of children. Misuse of this appliance can lead
to irreparable eye injuries.
- Any adjustment to increase the laser power is
forbidden.
, When using the laser pointer, do not point the laser
beam towards people and/or reflecting surfaces.
Even a laser beam of lower intensity may cause eye
damage. Therefore, do not look directly into the laser
beam.
- If the laser pointer is stored for more than three
months without use, please remove the batteries to
avoid damage from possibly leaking batteries.
- The laser pointer includes no servicing components.
Never open the housing for repair or adjustments.
• Laser Warning label: Max output <5mW Wavelength:
630-660nm, Complies with 21CFR 1040.10
and 1040.11. Class Ilia Laser Product.
f ...................................................................................................................................................................................................................................................................................................
LASER RADIATION-AVOID
DIRECT EYE EXPOSURE
Max.Output <5 mWWavelength: 630-660 nm
Complieswith 21 CFR1040.10and 1040.11
Class Ilia Laser Productj
• Do not remove or deface warning labels. Removing
labels increases the risk of exposure to radiation.
• CAUTION=Use of controls or adjustments or
performance of procedures other than those specified
herein may result in hazardous radiation exposure.
Do not attempt to repair or disassemble the laser level.
If unqualified persons attempt to repair this laser
product, serious injury may result. Any repair required
on this laser product should be performed by
authorized service center personnel.
• CAUTION=The use of optical instruments with this
product will increase eye hazard.
[,4kWARNINGI
DO NOT use tinted glasses to enhance the laser light.
Tinted glasses will reduce the overall vision for the
application and interfere with the normal operation of
the tool.
,_WARNING 1
LASER RADIATION. Never aim the beam at a work
piece with a reflective surface. Bright shiny reflective
sheet steel or similar reflective surfaces are not
recommended for laser use. Reflective surfaces could
direct the beam back toward the operator or by
standers.
ADJUSTING THE LASER LINES (FIG. S)
A. How to check the Laser=beam Alignment?
1. Adjust the table height so it is 5 in. below the bottom
of the chuck.
2. Scribe a round circle (approx. 1/8 in.) on a piece of
scrap wood.
3. Insert a drill bit approx 1/8 in. diameter into the chuck
and tighten.
4. Lower the quill and align the scribed circle with the
drill bit and fasten the wood to the table.
5. Turn on the laser and verify the laser lines (x) are
centered onto the scribed circle.
B. ALIGNING THE LASER=BEAM (FIG. S)
To adjust the laser lines:
1. Turn on the laser by pressing the rocker switch.
2. Lower the drill press quill and loosen one turn each
the four screws (4).
3. To adjust the laser beam left/right, turn the
adjustment screw (1) no more than 1/8 turn in either
direction. To adjust the laser beam front to back,
turn the adjusting screw (2) no more than 1/8 turn in
either direction.
4. Once adjustments are completed, retighten the four
screws (4).
Fig. S
4
18
Loading ...
Loading ...
Loading ...