Loading ...
Loading ...
Loading ...
CANISTER
1. Open the canister hood.
2. Check to see that the dust bag is
properly installed.See BAG CHANGING
(page 19)for instructions.
3. Check to see that the motor safety filter
isproperly installed. See MOTOR SAFETY
FILTERCHANGING (page 20) for
instructions.
HOOD AND TOOL STORAGE
COVER
It is normal for the canister hood and tool
storage cover to come off when opened
further than needed.
TO REINSTALL HOOD:
Hood
Bracket----.
1. Lift hood bracket
up as shown.
2. Align tabs located on the hood with slots
located on the hood bracket. Press hood
into hood bracket until it snaps in place.
_"_Tal_
Slots
Hood
3. Press hood slightly
towards the rear of
the canister.
4. Lower hood to
close. Pressuntil
hood latch snaps
into place.
Hood
TO REINSTALLTOOL STORAGE COVER:
1. Presstool storage cover bracket down.
Cover Bracket
2. Align front edges of tool storage cover
on canister hood.
3. Press rear of tool storage cover clown
until it snaps into place.
®,
HOSE
1. Line up the hose
latch tab and
notch in canister
hood and insert
hose into canister
until it snaps into
place.
Hose Latch
Tab.--
IMPORTANT:
Push hoseconnectorfirmly into the cansiter
body until the hose latch tab snaps into
place. The vacuum cleaner will not operate
until hose is fully connected.
To remove: Do not open hood before
removing hose. With hood closed, press
hose latch tab and remove hose.
-g-
Loading ...
Loading ...
Loading ...