Loading ...
Loading ...
Loading ...
15INSTALLATION
ENGLISH
Leveling the Washer
The drum of your new washer spins at very high
speeds. To minimize vibration, noise, and unwanted
movement, the oor must be a level, solid surface.
The slope beneath the washer should not exceed 1
inch, and all four leveling feet must rest rmly on the
oor.
NOTE
• Adjust the leveling feet only as far as necessary to
level the washer. Extending the leveling feet more
than necessary can cause the washer to vibrate
• Before installing the washer, make sure that the
oor is clean, dry and free of dust, dirt, water and
oil so the washer feet cannot slide easily. Feet
that move or slide on the oor can contribute to
excessive vibration and noise due to poor contact
with the oor.
1
Position the washer in its nal location.
Take special care not to pinch, strain, or
crush the water and drain lines. If you have a
carpenter's level, you can place it across the top
of the washer.
Level
1"
2
Adjust the lower leveling feet.
Turn in one direction to raise the washer or the
other direction to lower it.
Raise Lower
3
Tighten the locknuts.
Turn the locknuts counterclockwise and tighten
them when the washer is level.
Lock nut
Tighten all 4 lock
nuts securely
4
Recheck the washer’s levelness.
Push or rock the top edges of the washer gently
to make sure the washer does not rock. If the
washer rocks, repeat steps 1-3.
CAUTION
• Using the washer without leveling it may
cause excess vibration and noise, leading to a
machine malfunction.
• Extend the leveling feet only to level the washer.
If you extend the leveling feet unnecessarily, it
may cause abnormal vibration of the washer.
Using Non-Skid Pads
If you install the washer on a slippery surface, it
may move because of excessive vibration. Incorrect
leveling may cause malfunction through noise and
vibration. If this occurs, install the non-skid pads
under the leveling feet and adjust the level.
1
Clean the oor to attach the non-skid pads.
Use a dry rag to remove and clean foreign
objects or moisture. If moisture remains, the
non-skid pads may slip.
2
Adjust the level after placing the washer in
the installation area.
3
Place the adhesive side of the non-skid pad
on the oor.
It is most effective to install the non-skid pads
under the front legs. If it is hard to place the
pads under the front legs, place them under the
back legs.
This side up
Adhesive
side
Remove backing
4
Recheck the washer’s levelness.
Push or rock the top edges of the washer gently
to make sure that the washer does not rock.If
the washer rocks, level the washer again.
Loading ...
Loading ...
Loading ...