Loading ...
Loading ...
Loading ...
8
FINAL INSTALLATION
Figure 5.5
Figure 5.8 Figure 5.9
Figure 5.4
Figure 5.7
Figure 5.6
Blade Screw
Keyhole
Slot
Fitter Plate Screw
Blade Washer
Blade Arm
Blade Arm
Motor Screw
9-pin Connector
Blade
4. Partially insert the blade screws along with blade washer through blade and into the blade arm. Tighten each blade screw starting
with the one in the middle (Figure 5.4). Repeat this step for the remaining blades and blade arms (Figura 5.4).
5. Install the blade arms to the underside of the motor assembly using the ten previously removed motor screws (Figure 5.5).
6. Remove one of the three fitter plate screws from the fitter plate and loosen the other two. Then, connect the 9-pin connector
from the fan to the 9-pin connector from the light kit (Figure 5.6).
7. Lift the light kit and place the two keyhole slots in the light kit over the two loosened fitter plate screws. Turn the light kit
counterclockwise and secure it to the fitter plate with the previously removed fitter plate screw. Tighten all three screws
(Figure 5.7).
8. Install the three E26-base bulbs into the sockets of the light kit (Figure 5.8).
9. Remove the battery door from the back of the remote using a flat-head screwdriver (not included). Insert the two CR2032
batteries into the remote; ensure the positive pole of the batteries face up (as pictured) and then replace the battery door.
Press the HIGH SPEED button to ensure the LED indicator illuminates and the fan turns on (Figure 5.9).
Bulb
Battery
Battery Door
Loading ...
Loading ...
Loading ...