Loading ...
Loading ...
Loading ...
6
STANDARD OR ANGLE MOUNT INSTRUCTIONS
1. Remove the downrod pin and downrod clip from the downrod. Then partially loosen the set screws in the yoke at the top of the
motor assembly (Figure 3.1).
2. Feed the fan wires and braided cable through the yoke cover, canopy and downrod (Figure 3.2).
3. Slide the downrod into the yoke of the motor assembly. Align holes and reinstall the downrod pin and downrod clip and secure
with the two set screws (Figure 3.3).
4. Depending on the length of downrod you use, you may want to cut the fan wires to simplify wiring. After pulling the wires all
the way through the downrod, measure 8 inches of wire. Cut off the excess wire using wire cutters (not included) WARNING:
Do not cut the braided cable (Figure 3.4).
5. Install the ball end of the downrod into the opening of the mounting bracket (Figure 3.5). WARNING: Failure to align the slot
in the ball with the tap on the mounting bracket may cause the fan to fall, which could result in injury or death.
6. Insert the receiver inside the mounting bracket with the flat side facing the ceiling (Figure 3.5).
8 in.
Figure 3.4 Figure 3.5 Figure 3.6
Figure 3.1
Downrod Clip
Mounting
Bracket
Mounting
Bracket
Downrod
Downrod
Receiver
Downrod Pin
Set Screw
Downrod
Tab
Canopy
Slot
Yoke Cover
Figure 3.2 Figure 3.3
Downrod
Clip
Set Screw
Yoke
Downrod
Pin
Braided Cable
Braided Cable
Loading ...
Loading ...
Loading ...