Loading ...
Loading ...
Loading ...
3
RUNNING THE WIRING CABLES
**Always keep the signal cable and the power cables separated to prevent the
possibility of inducing noise into the system**
Carefully run the power and the signal cables through the boat. Always keep all
the wire tight and tied down to prevent the power wire from shorting and reduce
the risk of re. A 4 AWG or larger wire should be used for power and ground
connections. We recommend a fuse to be installed on the power wire within 18
inches of the battery for safety.
AMPLIFIER CONNECTIONS
**Make sure that the +12 volt cable is NOT connected to the battery while making
any of the connections until all the connections and the fuse are installed**
Power Connections
The HTX Series is designed for 4 AWG Power wire (+12 V) and Ground wire
(GND). You will need to prepare the wire by remove 5/8” on the protective shielding
on the power and ground wire. Then take a Phillips head screwdriver and back out
the screws on the terminal block. Insert the +12 volt wire into the +12V side of the
terminal block and then tighten the screw back into the terminal block. You will do
the same for the Ground wire. See below
Wet Sounds HTX Series Owner’s Manual
Loading ...
Loading ...
Loading ...