Loading ...
Loading ...
Loading ...
9
TROUBLESHOOTING
1. Check your fuse and replace if necessary.
2. Conrm your Ground wire has a good connection.
3. Make sure your remote wire and power wire has +12 Volts.
4. Make sure your battery has 12 volts.
5. Conrm that the amplier LED color is blue. If the light ashing is red than the
amplier is in protection mode. If the light is red check the following items below:
A. See what sequence is ashing by referencing the chart below
B. Conrm that a/the speaker is not blown.
C. Conrm that there are no loose wires that could be grounding out the
amplier.
D. Check that the amplier has sufcient air circulation where it is
located. Insufcient air ow and overdriving the audio system could
result in the amplier going into protection to preserve the amplier.
If you are experiencing problems with your amplier after
installation follow these procedures to try and remedy the
problem.
Wet Sounds HTX Series Owner’s Manual
F
or HTX 4, 6 amplifiers, a short will only shut down the channels which are in fault. The other channels will
contiunue to play
. After a fault connec
tion is cleared, the error code will continue to flash, while the logo is
still illuminated blue. Please contact Tech Support for additional assistance, questions, etc.
Wet Sounds HTX Fault Codes
Circuit Board
Loading ...
Loading ...
Loading ...