Loading ...
Loading ...
Loading ...
16 www.dimplex.com
Back
Ledge
Log
Ember Bed
Rear
Tab
Front
Edge
Side Section
Figure 7
ness.
11. Install the Log Set Assembly
by placing the front, bottom
edge of the Ember Bed in the
track behind the control panel.
Once in place, push down on
the back edge of the Ember
Bed until the rear tab snaps
into place under the Mirror
(Figure 7).
!
NOTE: Ensure the Log Set
Assembly is installed tightly
under the back ledge to pre-
vent light leakage.
12. Slide front glass back into
position and attach trim.
Upper Light Bulb Requirements
Quantity of two (2) clear chande-
lier or candelabra bulbs with an
E-12 (small) socket base, 15 Watt
rating. Do not exceed 15 Watts
per bulb.
To access the upper light bulb
area:
CAUTION: Allow at least ve
minutes for light bulbs to cool off
before touching bulbs to avoid ac-
cidental burning of skin.
1. Slide replace out of mantel.
2. Remove four Phillips screws
from right side of trim (Figure
6).
3. Remove trim.
4. Slide glass to the right side of
the replace to remove (Figure
6).
5. Remove Upper Light Bracket
(Figure 6).
6. Upper bulbs are located in
the upper left and upper right
corners of the replace.
7. Unscrew bulbs counter clock-
wise.
8. Insert new bulbs and screw in
clockwise.
9. Re-install Upper Light Bracket.
10. Slide front glass back into
position and attach trim.
Purire™ Filter
The Purire™ lter supplied in
your replace is reusable and
washable. The lter should be
cleaned or replaced on average
Maintenance
Loading ...
Loading ...
Loading ...