Loading ...
2
Antenna Connection
For the direct antenna or the
antenna extension kit.
“SOFT” Keys
Soft key functions are defined by
the label on line 5 of the display.
The functions change according
to the menu selection.
LCD Screen
System programming and status
display.
Down/Up Keys
For navigation in the menus.
Numeric Keypad
Numeric data is entered
through the numeric keypad.
Insert wiring
USER INTERFACE
The PPWR user interface consists of a 22 character by 5 line LCD display, 3 “soft keys”, Down/Up arrows and a numeric keypad.
Line 1:
Menu and function mode.
Lines 2, 3, and 4:
Menu selections and data.
Line 5:
Soft key function modes.
Scroll Indicator
If more than 3 options exist, a scroll indicator appears on the
left margin of lines 2, 3, and 4. The scroll indicator shows the
relative position within the list.
Menu/Data selection shown
in inverse font.
Backup memory module indicator
(LiftMaster
®
logo screen only)
MAIN MENU COMMAND DESCRIPTION
WIEGAND FORMAT
26 BIT (DEFAULT) 26 Bit Wiegand output code.
30 BIT 30 Bit Wiegand output code.
31 BIT 31 Bit Wiegand output code.
34 BIT EVEN 34 Bit EVEN Wiegand output code.
34 BIT ODD 34 Bit ODD Wiegand output code.
50 BIT 50 Bit Wiegand output code.
BUTTON FILTER
BUTTON 1 IS ON Used when multiple receivers are within range of each other. Button filter selects which
button the PPWR receiver responds to. Used in areas where of overlapping receiver
coverage. Default setting is: Button 1,2,3 ON.
BUTTON 2 IS ON
BUTTON 3 IS ON
MODE SELECT
PASS THRU (DEFAULT) Passes all received remote control signals to the access system host controller.
ADVANCED Receiver only passes signals from a remote control with a previously programmed facility
code. All other remote control facility codes are blocked.
SECURITY TABLE
If ADVANCED MODE is
turned off this option is
disabled and will appear
as NOT AVAILABLE FOR
PASS THRU MODE
PROGRAM Learn a facility code from any remote control in a batch that the PPWR will respond to.
Also used to resolve any conflicts in code translation.
NOTE: Once Advanced Mode is enabled, Facility Codes of all remote controls to be used
on site must be added to the Security Table.
LIST CHANGE FC OUT Displays a list of all programmed facility codes showing facility code conflicts and facility
code changes. Options to delete or resolve facility code conflicts. Security Table can hold
up to 64 entries. MAX FC and FC IN > FC OUT entries can be configured to translate FC IN
to a specified FC OUT. Each FC IN can only have one FC OUT.
DELETE
SETTINGS
PIN Change the 6-digit PIN number for the receiver.
DEALER INFO Display and edit the dealer 10-digit phone number.
FIRMWARE VERSION Displays the current firmware version.
BEEP Turn the audible feedback on or off.
MEMORY
This function creates a complete backup of programmed remote controls, and Security
Table settings. The backup may be restored to a replacement PPWR or used to copy the
configuration into other PPWR
DUPLICATE MEMORY
Creates a memory backup. A memory module must be installed.
RESTORE MEMORY Restores a memory backup from a memory module. An indicator appears on the
LiftMaster
®
logo screen if a backup memory module is installed.
NOTE: Content of memory module will over-write any information already stored in the
receiver memory. Remove memory module after backing up for safe keeping.
CONTRAST Press Down or Up arrows to adjust LCD contrast.
LANGUAGE Sets language: English (Default), Spanish, and French.
FACTORY DEFAULT Reset receiver settings to factory default. NOTE: If a PIN is set and lost the Reset Pin
function must be used to unlock the PPWR unit.
PROGRAMMING COMMANDS
The table below describes the commands used to program the receiver.
Loading ...
Loading ...
Loading ...