Loading ...
TOOLS HEEDED:
ARNING
" ALL RANGES CAF._TIP
° INJURY TO PERSONS
COUL_ RESULT
iNSTALL ANTI-TiP
DEVSCE PACKED
WITH RANGE
SEE INSTALLATION
INSTRUCTIONS
='="'='= =1 ..................
STABlUTY DEVICE _STALLATiON iNSTRUCTiONS
FOR BRACKET KiT NO. 342473
Phillips head screwdriver
1 3/8" open end o_ _djustable wrench
Bracket altachesto floor or wall to hoid etther right or left
rear leg leveler° If fastening to floor, be sure that screw5
do not penetrate electrlcal wiring or plumbing if this
cannot be determined, use shorter screws _hat wltt no_
penetrate through flooring.
If the bracket came with your range, it ]._st]tpped In the
pr_pack located Inside the oven. F_emove the bracket
from Ihe prepack and follow the Instructions be!ow,,
I. Decide whether the bracket will be Installed on ti_e
right or left slde of range location.
2, ff the bracket side of the range is adiacent to a
cabinet, place the bracket against back wal! and
cabinet as shown in Figure 1.
tf ii]e_-e is no adjacent cabinet, determine where the
_,oc_tlon of the range side (palnt _d outside panel) wi!i
bee Place the bracket with Its outside edge at this
location and against back wall. See Figure 1.
OUTSIDE EDGE OF
BRACKET TO BE
FLUSH WITH LEFT OR
IGHT SIDE OF RANGE
WALL BEHIND
RANGE\I
ADJACENT CABINET OR FINAL,
! rJCAT]ON OF RANGE SIDE
PANEL
Fig. 1
3_ Determine whether you will anchor the bracket to the
floor or wall. Fasten the bracket securely with the
screws provided. Screws are self-drilling In wood,
plywood, particle and chip board, and most metal
framing. Ifattachlng tomasonry, youcanbuysultable
screws and anchors at hardware stores. Use a
masonry drill to drill the required holes,
4. Ustng the wrench, back out the four leg levelers at
least twoturns. See your lnstallatlon guide formore
leveling Information before positioning range,
5. Slide the range Into place. Be sure rear leg leveler
fully engages slot in bracket, tf range cannot be
moved back far enough for rear leg leveler to enter
bracket, move bracket forwa rd as required and attach
to floor In new location.
BRACKET
\
SCREWMUSTENTER
WOOD ORMETAL
WALL
PLATE
/
ATTACHMENT TO WALL
Fig. 2
NCINS01-3
Loading ...
Loading ...
Loading ...